Setting⑥: Led Control - Mitsubishi Electric KD Series User Manual

Address Register name
7010 LedSelector
5-2-7 LED Control
[Function]
This function controls LED lighting.
On CX series, the built-in LED can be controlled.
ONCX-NL series (non-lighting type), the External LED
pulse signal is output.
Glass
TM-XH719C
5-2 Setting⑥: LED control
※On CX-NL series, LED Control functions as External LED pulse signal control.
R/W Val
LED lighting control
0: OFF
R/W 0 to 3
1: Upper-stream side LED-A, one side lighting ON
2: Lower-stream side LED-B, one side lighting ON
3: Both Upper-stream LED-A and Lower-stream LED-B ON
Upper-stream side LED-A
Lower-stream side LED-B
COPYRIGHT©2017-2020 MITSUBISHI ELECTRIC CORPORATION. ALL RIGHTS RESERVED.
Result
[Remark]
1) Sequential multiple different LED lightings (both
External LED and built-in LED) are not supported by
this product. In this case, White Correction cannot be
operated, too. When you select one of the LED control
modes, you can save White Correction data and run
White Correction.
2) As LED Control function, CX-NL series outputs External
LED pulse signal over External Connector L1. For more
details, refer to Page 54.
Initial
3
78