Setting⑫: Γ Correction - Mitsubishi Electric KD Series User Manual

5-2 Setting⑫: γ correction
Address Register name R/W Val Result Initial
Set γ correction On/Off
70E0 GammaCorrectionEnable R/W 0 or 1 0
0:OFF /1:ON
5-2-13 γ correction function
[Function]
Change output linearity based on Look-up table (γ
correction table).
The initial setting is γ=1 (γ correction OFF).
[Factory setting at look-up table]
γ table : γ=2.2
[Remark]
1)γ correction selects or specifies a gradation of 256 steps
(8 bit length), that is one of 4 blocks that 1024 steps (10bit
length) are divided by 4.
2)For more details of γ correction, refer to the Function
Specification.
84
TM-XH719C
COPYRIGHT©2017-2020 MITSUBISHI ELECTRIC CORPORATION. ALL RIGHTS RESERVED.