Mitsubishi Electric KD Series User Manual page 52

3-2-1 Preparation by users
① DC24V power cable
Following cable connectors are recommended.
Housing
Contact socket
CIS connector is DAU-9P-F0R (JAE), and the contact pin
is 030-50635 (JAE)
Pin assignment of CIS connector is as shown below
LED embedded (KD-CX series)
Pin
Name
No
1 +24V power
2
3
ＮＣ
4
5
6 ＧＮＤ
7 LED_CONT
8
ＮＣ
9
TM-XH719C
3-2 Preparation
: DAU-9S-F0R (JAE）
: 030-50634 (JAE）
V4
V2,V4
I/O Remarks
I V
LED
-
I GND
LED
OPEN： LED off
I
GND： LED on
-
COPYRIGHT©2017-2020 MITSUBISHI ELECTRIC CORPORATION. ALL RIGHTS RESERVED.
By using 7th pin "LED _CONT" control signal port, the
illumination ON/OFF can be directly controlled. Control with
open collector circuit. connect to GND with low impedance.
If the direct control of the illumination is not necessary,
connect 7 pin to GND with low impedance.
【Reference】
1
6
No7 Pin
7
To LED driver
circuits
【Remarks】
When you use a cable in the field as the power cable,
confirm the connection and the cable length and standard
carefully.
Cable resistance 120mΩ or less between the power supply
and CIS is recommended.
(Cable standard AWG22： approx. 2m, AWG20： approx.
3m, AWG18： approx. 5m)
To other system
circuits
52