Restriction For Use - Mitsubishi Electric KD Series User Manual

Thank you very much for purchasing Mitsubishi Electric Contact Image
Sensor (CIS). This document contains information that introduces how to
use this product appropriately and safely. Read through this document
carefully before starting to use this product in your equipment or system.
This product is designed for the purpose of being used in general industries. Do not use this product for
specific and particular applications (aerospace application, combustive equipment, transportation
equipment, life-support system, safety device, etc.) where special quality and reliability are required and
failure or malfunction could directly threaten people's lives, or do harm to the human body. Do not use for
applications other than the purpose of being used in general industries intended by Mitsubishi Electric. If
you plan to use such particular applications, contact our sales department personnel before doing so. If
you have be used it for applications other than the general industries intended by Mitsubishi Electric
without consulting our sales department personnel, Mitsubishi Electric SHALL HAVE NO
RESPONSIBILITY OR LIABILITY (INCLUDING, BUT NOT LIMITEDTO ANY AND ALL RESPONSIBILITY
OR LIABILITY BASED ON CONTRACT, WARRANTY, TORT, PRODUCT LIABILITY) FOR ANY INJURY
OR DEATH TO PERSONS OR LOSS OR DAMAGE TOPROPERTY CAUSED BY the PRODUCT.
Determine the applicability of this product to your equipment or devices through an
appropriate analysis or evaluation by the designer of such equipment or devices, or
personnel related to the specification. Such designers or personnel shall warrant the
performance and safety of your equipment or devices such as dust-proof, water-proof, EMC
and EMI, by themselves.
Design, specification and the contents of this document are subject to change without
notice.
TM-XH719C

1-1 RESTRICTION FOR USE

COPYRIGHT©2017-2020 MITSUBISHI ELECTRIC CORPORATION. ALL RIGHTS RESERVED.
4