Configuring Corrections; Duty Cycle Corrections; [Sense<Sensor>:]Correction:dcycle; [Sense<Sensor>:]Correction:dcycle:state - R&S NRP Series User Manual

®
R&S NRPxxA(N)
Manual operation:

9.8.3 Configuring corrections

It is possible to set some parameters that compensate for a change of the measured
signal due to fixed external influences.
● Duty cycle
● Offset
● S-parameter
● S-gamma
● I-gamma
● Using the S-Parameters
9.8.3.1

Duty cycle corrections

The duty cycle is the percentage of one period during which the signal is active, when
pulse-modulated signals are corrected. The duty cycle is only evaluated in the continu-
ous average mode.
Remote commands:
[SENSe<Sensor>:]CORRection:DCYCle
[SENSe<Sensor>:]CORRection:DCYCle:STATe
[SENSe<Sensor>:]CORRection:DCYCle <duty_cycle>
Available in continuous average mode.
Sets the duty cycle for measuring pulse-modulated signals. The duty cycle defines the
percentage of one period during which the signal is active. If the duty cycle is enabled,
the R&S NRPxxA(N) considers this percentage when calculating the signal pulse
power from the average power.
Parameters:
<duty_cycle>
Manual operation:
[SENSe<Sensor>:]CORRection:DCYCle:STATe <state>
Enables or disables the duty cycle correction for the measured value.
Parameters:
<state>
Manual operation:
User Manual 1177.6017.02 ─ 08
See "Frequency"
corrections............................................................................................. 90
corrections.................................................................................................... 91
correction........................................................................................... 91
corrections.............................................................................................. 92
queries..................................................................................................... 94
program........................................................................... 95
Range:
*RST:
Default unit: Percent
See "Duty Cycle"
*RST:
See "Duty Cycle"
Remote control commands
Configuring basic measurement parameters
on page 42
............................................................................ 90
.................................................................. 90
0.001 to 100.00
1.00
on page 44
OFF
on page 44
90