Turn On/Off Ground Station; Frequency Pairing Of The Aircraft And The Ground Station - Autel Robotics Dragonfish Pro User Manual

Hide thumbs Also See for Dragonfish Pro:
Table of Contents

Advertisement

3.2.2 Turn on/off ground station

Power on
Press and hold the power button (
panel will light up, and startup inspection will commence.
Important
Always turn the remote controller on before turning on the aircraft's power.
Power off
Press and hold the power button (
Important
Always turn off the aircraft power before turning off the remote controller.

3.2.3 Frequency pairing of the aircraft and the ground station

The ground station and the aircraft have been paired in the factory. If they need to be paired again,
please carry out the following operations:
1. Refer to the Section of 2.2.1, enter the aircraft setting interface, select the option of remote
controller, and open the option of remote controller calibration.
2. Follow the prompts to remove the battery from the rear of the aircraft, press and release the
battery button, and make sure the indicator is quickly flashing.
3. Click "Confirm after completing the above operations" on the App interface, and then click
"Start connection".
4. Wait for frequency pairing. After frequency pairing succeeds, the battery indicator will flash
slowly. Finally put the battery back to the aircraft.
) for 2s until you hear a short beep. The flight information
) for 2s until you hear a short beep.
25

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Dragonfish Pro and is the answer not in the manual?

Table of Contents