Evaluation And Test; Setting Up The Spi Controller Software - Analog Devices AD9681 Quick Start Manual

Analog-to-digital converter

Table of Contents

Evaluation And Test

After the ADC data capture board setup is complete, set up the SPI controller software using the

following procedure:

Open the SPI controller software by going to the Start menu or by double-clicking the

SPIController software desktop icon. If prompted for a configuration file, select .cfg file whose

name begins with AD9681. If not prompted, check the title bar of the window to determine which

configuration is loaded. If necessary, choose Cfg Open from the File menu and select the

appropriate file based on your part type. Note that the CHIP ID(1) box should be filled to indicate

whether the correct SPI controller configuration file is loaded (see Figure 7).

Figure 6. VisualAnalog, Main Window Expanded Display

Rev 13 Nov 2013 01:53 | Page 10

Table of Contents