Table of Contents
Advertisement
installation
Gi29 Panel Installation
(Part # 311-901, 311-903, 311-904, 311-905, 311-906, 311-907)
Panel Installation
• Brick/steel/glass panels may discolor a little during operation. This is normal and should not be considered a defect.
• Black glass panels: All hand and fingerprints MUST be cleaned off with a soft cloth. Use an ammonia-based cleaner (i.e. glass cleaner) to
remove prints before applying heat to the unit. Failure to do this will result in stains which you will be unable to remove - this issue is not
covered by our product warranty.
1. Carefully remove the panels from the box. They are fragile - handle with care and do not force them into position. If installed, remove the glass
front prior to installing the panels.
*The front panel in the steel/black glass panel set is a single part. The front panel in the brick panel set is split into two parts.
2. Loosen screws and remove brick retainer brackets.
34
| Gi29 Direct Vent Gas Insert
920-431
*
3. Insert the rear panel and hold in place while installing the left and right
panels.
• The brick panel sets must be installed with the arrow on the back
of the panel pointing up to align the grout lines.
*The glass panel set (311-906) must be installled with the smaller tabs
on the top.
1
02.10.22
Advertisement
Table of Contents
