Table of Contents
Advertisement
operating instructions
OperatingProcedureforRemoteControl
FunctionalityoftheReceiver
The receiver is supplied by four AA batteries (see
Fig. 3). The receiver accepts commands via radio
signals sent from the transmitter. The receiver sends
commands by the wire harness to the multifunctional
gas control. When the system is turned on, an
acoustic signal (beep) is generated to indicate that
the receiver is ready to receive commands from
the remote control.
TurnontheAppliance
When the ON/OFF key is pressed, the LED on the
transmitter illuminates and the remote control is
switched on. At the same time, the receiver connects
the thermopile to the gas valve millivolt coil and the
appliance main burner turns on in the high position.
A single acoustic signal from the receiver confirms
the reception of the command.
TurnOfftheAppliance
If the appliance and the remote control are
switched on and the ON/OFF key is pressed, the
remote control is turned off. At the same time, the
receiver removes power from the gas valve millivolt
coil and the appliance main burner turns off. A
double acoustic signal from the receiver confirms
the reception of the command.
62
| Gi29 Direct Vent Gas Insert
LowBatteryDetection(Receiver)
The duration of the remote control batteries depends
on many factors: the quality of the batteries used,
the number of ignitions of the appliance, etc. If
the receiver batteries are low, a triple acoustic
signal is emitted by the receiver when it receives
a command from the transmitter. This is an alert
of a low battery condition before battery power is
lost altogether. As soon as the depleted batteries
are replaced, the acoustic signal from the receiver
confirms the reception of the ON/OFF command
from the transmitter.
BackupFunction(IfOptional
RemotewasPurchased)
If the batteries of the receiver are low, the appliance
can be switched on manually by moving the three-
position slider switch on the receiver to the ON
position.
WarningsandCautions
• Fire hazard. Can cause severe
injuryordeath.
• The receiver causes the ignition
of the fireplace. The fireplace
canturnonsuddenly.Keepaway
fromtheburner,especiallywhen
operatingtheBACKUPswitch.
• P r o p e r t y d a m a g e h a z a r d .
Excessiveheatcancauseproperty
damage.
• Thefireplacecanstayignitedfor
manyhours.Takecaretoturnoff
thefireplaceifitisunattendedby
adults. Do not leave the remote
controlwherechildrencanreach
it.
Advertisement
Table of Contents
