Table of Contents
Advertisement
Detaching the CS
from a pole
step-by-step
4.1.6
Install Leica Viva
USB drivers
GS25, Operation
Step
Description
8.
After the CS field controller is
placed onto the mounting plate,
ensure that the locking pin is put
into the locked position. To lock
the locking pin, push the locking
pin to the right.
Step
Description
1.
Unlock the locking pin by pushing the locking pin to the left of the mounting
plate.
2.
Place palm over the top of the CS until fingers grip the bar of the holder
underneath.
3.
Push from the top of the CS toward the bar of the holder.
4.
While in this position, lift the top of the CS from the
holder.
Connecting to a Personal Computer
Microsoft ActiveSync (for PCs with Windows XP operating system) or Windows Mobile
Device Center (for PCs with Windows Vista or Windows 7/Windows 8 operating
system) is the synchronisation software for Windows mobile-based pocket PCs. Micro-
soft ActiveSync or Windows Mobile Device Center enables a PC and a Windows mobile-
based pocket PC to communicate.
Step
Description
1.
Start the PC.
2.
Insert the Leica Viva Series USB card.
3.
Run the SetupViva&GR_USB_XX.exe to install the drivers necessary for
Leica Viva devices. Depending on the version (32bit or 64bit) of the oper-
ating system on your PC, you have to select between the three setup files
following:
• SetupViva&GR_USB_32bit.exe
• SetupViva&GR_USB_64bit.exe
• SetupViva&GR_USB_64bit_itanium.exe
The setup has to be run only once for all Leica Viva devices.
4.
The Welcome to InstallShield Wizard for Leica Viva & GR USB drivers
window appears.
Ensure that all Leica Viva devices are disconnected from your PC
before you continue!
5.
Next>.
TS_054
1
TS_057
2
33
Advertisement
Table of Contents
