Table of Contents
Advertisement
Connect USB cable
to PC for the first
time step-by-step
GS25, Operation
Step
Description
6.
The Ready to Install the Program window appears.
Install. The drivers will be installed on your PC.
7.
For PCs with Windows Vista or Windows 7/Windows 8 operating
system: If not already installed, Windows Mobile Device Center will
be installed additionally.
8.
The InstallShield Wizard Completed window appears.
9.
Check I have read the instructions and click Finish to exit the wizard.
4
GS25_005
Step
Description
1.
Start the PC.
2.
Plug the GEV234 cable into Port P1 of the instrument (GS25).
3.
Turn on the instrument.
4.
Plug the GEV234 cable into the USB port of the PC. The Found New Hard-
ware Wizard starts up automatically.
5.
Check Yes, this time only. Next>.
6.
Check Install the software automatically (Recommended). Next>. The
software for Remote NDIS based LGS GS Device will be installed on your
PC.
7.
Finish.
8.
The Found New Hardware Wizard starts up automatically a second time.
9.
Check Yes, this time only. Next>.
10.
Check Install the software automatically (Recommended). Next>. The
software for LGS GS USB Device will be installed on your PC.
Finish.
11.
For PCs with Windows XP operating system:
12.
Run the ActiveSync installation program if not already installed.
13.
Allow USB connections inside the Connection Settings window of
ActiveSync.
For PCs with Windows Vista or Windows 7/Windows 8 operating system:
14.
Windows Mobile Device Center starts up automatically. If does not start
automatically, start Windows Mobile Device Center.
3
2
E1
34
Advertisement
Table of Contents
