Table of Contents
Advertisement
AGA INSULATING LID HINGE ASSEMBLY (Introduced 2005)
The insulation lids are supplied complete with the hinge fitted. The hinge end bearing locking grub
screws (A) 2 off are supplied loose.
Ensure the lid is sitting evenly in the closed position. Adjust the level of the lid if required, by turning
the adjustable bearing (located inside the ends of the hinge) with a pozi drive screwdriver, through
the tapped holes in the cast iron lid.
When the desired level of the lids is achieved, lock the bearing with the flat face locking scrub grub
screw using an allen key.
Open and close the lids a few times to check the adjustable bearings are positively locked in and the
lids are sitting evenly
With AGA Rangemaster's policy of continuous product improvement, the Company reserves the right to
change specifications and make modifications to the appliances described and illustrated at any time.
Page 34 of 34
Advertisement
Table of Contents
