To Reset The Pcb After A Fault Condition; Tek Vision Software - AGA RANGEMASTER eR7 Field Service Manual

To reset the PCB after a fault condition

Press and hold the reset button located on the front left hand side of the PCB.
Customers should not be instructed on how to reset the PCB.
The main PCB screen will first display "clearing locks" it's important to keep pressing the reset
button until the screen displays "system reset."
The screen will then display FW (Firmware) version followed by Stand- by.
The reset procedure is now complete, the controls will have gone into stand – by and all error codes
in the temporary fault log will be cleared, the permanent fault log will not be cleared by a reset.
Note: Occasionally the reset procedure may not clear an error on the first attempt so a second or
third attempt may be necessary.

TEK Vision software

There are 3 other screens within the TEK Vision Software that are useful to a field technician. The
communication tab is not used by service technicians.
Page 18 of 34