Jreset; Jsave; Jshow - CSI Wireless Vector Sensor Reference Manual

6.3.13 $JRESET

This command is used to reset the Vector Sensor GPS engines to their default operating
parameters.
This message has the following format.

6.3.14 $JSAVE

Sending this command is required after making changes to the operating mode of the Vector
Sensor in order to ensure the changes are present for the subsequent power cycle.
$JATT commands do not require a $JSAVE command to be issued as their function is
automatically saved.
This command has the following structure.
The Vector Sensor will reply with the following two messages. Ensure that the receiver indicates
that the save process is complete before turning the receiver off or changing the configuration
further.
No data fields are required. The receiver will indicate that the configuration is being saved and will
notify you when the save is complete.

6.3.15 $JSHOW

This command is used to poll the Vector Sensor for its current configuration.
This command has the following structure.
Using the $JSHOW command without the optional ',subset' field will provide a complete response
from the receiver. An example of this response follows.
Vector Sensor Reference Manual
$JRESET<CR><LF>
$JSAVE<CR><LF>
$> Saving Configuration. Please Wait...
$> Save Complete
$JSHOW[,subset] <CR><LF>
69