$>JSHOW,BAUD,9600
$>JSHOW,BAUD,9600,OTHER
$>JSHOW,ASC,GPGGA,1.0,OTHER
$>JSHOW,ASC,GPVTG,1.0,OTHER
$>JSHOW,ASC,GPGSV,1.0,OTHER
$>JSHOW,ASC,GPGST,1.0,OTHER
$>JSHOW,ASC,D1,1,OTHER
$>JSHOW,DIFF,WAAS
$>JSHOW,ALT,NEVER
$>JSHOW,LIMIT,10.0
$>JSHOW,MASK,5
$>JSHOW,POS,51.0,-114.0
$>JSHOW,AIR,AUTO,OFF
$>JSHOW,FREQ,1575.4200,250
$>JSHOW,AGE,1800
This example response is summarized in the following table.
Line
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
When issuing this command with the optional ',subset' data field (without the square brackets), a
one-line response is provided. The subset field may be either CONF or GP.
When CONF is specified for 'subset', the following response is provided.
This response is summarize
Message
Component
Vector Sensor Reference Manual
Description
This line indicates that the current port is set to a baud rate of 9600.
This line indicates that the other port is set to a baud rate of 9600.
This line indicates that GPGGA is output at a rate of 1 Hz from the other port.
This line indicates that GPVTG is output at a rate of 1 Hz from the other port.
This line indicates that the GPGSV is output at a rate of 1 Hz from the other
port.
This line indicates that GPGST is output at a rate of 1 Hz from the other port.
This line indicates that D1 is output at a rate of 1 Hz from the other.
This line indicates that the current differential mode is WAAS
This line indicates the status of the altitude aiding feature.
This line indicates the threshold of estimated differential performance that allows
the green DGPS LED to illuminate
This line indicates the current elevation mask cutoff angle, in degrees.
This line indicates the current seed position used for startup, in decimal degrees.
This line indicates the current status of the AIR mode.
This line indicates the current frequency of the L-band receiver
This line indicates the current maximum acceptable differential age in seconds.
$>JSHOW,CONF,N,0.0,10.0,5,A,60W
d in the following table.
Description
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(10)
(11)
(12)
(13)
(14)
(15)
70
Need help?
Do you have a question about the Vector Sensor and is the answer not in the manual?