Advertisement
Trigger (input): When a TTL pulse (rising/ falling edge) is detected, the
A
TRIGGER
camera triggers.
Ready: Outputs a TTL signal (high) to indicate that all cameras connected to
B
READY
the Miro JBox 2.0 are in Capture Mode. Signal can be set to go low at trigger
or at the end of recording.
TC In (input): Connects to an IRIG receiver to accept an unmodulated signal to
C
TC IN
drive the Miro Junction Box IRIG signal generation.
D
AUX IN
Aux IN: The following inputs can be used in this port:
•
•
•
TC Out (output): Connect to a second Phantom camera, to drive the camera's
E
TC OUT
frame rate. Use in combination with Sync: Lock to IRIG in the External Sync
menu.
F
AUX OUT
Aux OUT: The following outputs can be used in this port:
•
•
G
POWER 7-32VDC
Ethernet: Ruggedized RJ45 connector connects GigE to a control unit
H
ETHERNET
computer / laptop for camera control communication.
I
POWER 7-32VDC
System Connector: Same Fischer connector as System port on JBox 2.0.
J
SYSTEM
The Control BoB must connect to the System Port (not a Camera Port)
of the JBox 2.0 to function as designed.
EVENT (input): When the Event signal is active, frames are tagged with
an Event marker (as metadata). These
events can be searched or referenced during playback.
MEMGATE (input): When Memgate signal is active the camera stops
recording into its internal memory (frames are discarded).
F-SYNC (input): Connect an external source, including the F-Sync from
a second Phantom camera, to drive the camera's frame rate. Use in
combination with Sync: External in the External Sync menu.
STROBE (output): Signal goes low for the duration of each frame's
exposure.
F-SYNC (output): FSYNC output from active camera connected to the
Miro Junction Box.
Power Connector: Amphenol connector for rugged applications for
customer supplied power supply 7-32VDC, 500mA.
Power Connector: Barrel connector for power supply
7-32VCD, 500mA.
Chapter 8: Accessories | 35
Advertisement
