Advertisement
Aux 1 (input / output switchable):
D
AUX 1
Aux: 2: (output switchable):
E
AUX 2
F
TRIGGER
Vision Research, Inc. | Miro C 321/C 321J/N5/JBox 2.0 Camer a Manual
•
STROBE (output): Signal goes low for the duration of each
frame's exposure.
•
EVENT (input): When the Event signal is active, frames are
tagged with an Event marker (as metadata). These events can be
searched or referenced during playback.
•
MEMGATE (input): When Memgate signal is active the camera stops
recording into it's internal memory (frames are discarded).
•
F-SYNC (input / output): Connect an external source, including
the F-Sync from a second Phantom camera, to drive the camera's
frame rate. Use in combination with Sync: External in the External
Sync menu.
•
READY (output) When signal is high it indicates that the camera is
in capture mode. Using PCC, signal can be set to go low at trigger
or at the end of recording.
•
STROBE (see Aux 1 description above).
Trigger (input): When a TTL pulse (rising/ falling edge) is detected,
the camera trigger isolated, <1V deassert, 3 to 24V assert.
Advertisement
