Advertisement
POWER ON CAMERA
Connect the camera's dedicated power supply to the Primary DC input or connect via
system cable to the Miro JBox. The camera is ready for operation when the red capture
light of the Trigger button is illuminated.
LAUNCH PCC SOFTWARE
Double-click the PCC icon located on the desktop. Camera will be recognized
immediately if connected and network settings are correct.
SELECT CAMERA FOR USE
In the 'Manager' tab, select the Phantom camera to be used from the 'Cameras' group
folder. Click the 'Live' tab.
DEFINE RECORDING PARAMETERS
Click 'Cine Settings' and define the following parameters by either selecting the value
from the pull-down selection list or typing a value into the respective data entry field.
1.
Set 'Resolution' to the required Width x Height.
2. Choose the required 'Sample Rate,' and 'Exposure Time'
3. Set 'Post Trigger' to zero (0) by moving the 'T' (Trigger Position) slider to the right,
or enter zero (0) into the 'Last' data entry field.
Cover the lens and click the 'CSR' button to perform a Current Session Reference. A
CSR is a black reference for that session. It is required before capturing the first cine
and after changing any recording parameters.
With color cameras, perform a White Balance by right-clicking an area of the image that
is neutral gray or white, as long as it is not 100 percent saturated.
SET DEFAULT CSR
For customers that rarely change their camera settings, the "Set new CSR default"
feature provides a convenient alternative to this process. It is available in versions of
PCC 3.77 and higher. The camera must operate at full resolution, for example 1920 x
1080 for the C321. The Set Default CSR is set for the frame rate and exposure time being
used. That CSR will remain through turning the camera off and on, for as long as that
setting is not changed.
Vision Research, Inc. | Miro C 321/C 321J/N5/JBox 2.0 Camer a Manual
Advertisement
