Advertisement
PHANTOM VIDEO PL AYER (PVP) APPLICATION OVERVIE W
PVP can be launched directly from the
desktop shortcut or by the 'Video Out'
toolbar button in PCC.
PVP controls the video outputs
connected to a video monitor or
viewfinder only.
PVP provides the ability to view,
capture, review, edit and/or save a
Cine recorded into the camera's RAM,
to a hard drive or installed Phantom
CineMag. PVP is extremely effective
when used with high-resolution
cameras since most computers will not
play captured raw files smoothly.
The camera's video system and display settings are also set through PVP. The best
video system for the project will vary based on the country you are in, what kind of video
monitor is used and the required video resolution.
All available video systems for the connected cameras can be found in the 'Settings'
menu of PVP, along with production area and other video overlay controls.
CAMER A CONTROL VIA PCC
PCC provides the ability to select units for specific camera
parameters by clicking the 'Preferences' button at the
bottom of the 'Manager' tab.
Units can be set to commonly used values ('Presets') or can
be customized using the pull-down selection lists. First time
users should use one of the three 'Presets.'
The 'Exp' unit is probably the most important unit to be set.
It specifies what unit to use when setting the exposure time.
The other units to set are EDR (Extreme Dynamic Range, not
compatible on all models) and PTF (Post Trigger Frames)
covered later in this section.
Vision Research, Inc. | Miro C 321/C 321J/N5/JBox 2.0 Camer a Manual
Advertisement
