JLG 1250AJP Operation And Safety Manual page 52

2. Start/Auxiliary Power
When pushed forward, the switch energizes the starter
motor to start the engine.
When pushed back, it energizes the electrically operated
hydraulic pump, when actuated. (Switch must be held ON
for duration of auxiliary pump use.)
3. Capacity Select
This switch allows the operator to select between an operat-
ing envelope with a 500 lb. (227 kg for ANSI markets and 230
kg for CE and Australia markets) capacity restriction or a
1000 lb. (454 kg for ANSI markets and 450 kg for CE and Aus-
tralia markets) capacity restriction.
3121170
SECTION 3 - MACHINE CONTROLS AND INDICATORS
4. Drive Orientation Override
When the boom is swung over the rear tires or further in
either direction, the Drive Orientation indicator will illumi-
nate when the drive function is selected. Push and release
the switch, and within 3 seconds move the Drive/Steer con-
trol to activate drive or steer. Before driving, locate the black/
white orientation arrows on both the chassis and the plat-
form controls. Move the drive controls in a direction match-
ing the directional arrows.
NOTE: To operate the Drive Joystick, pull up on the locking ring below
the handle.
NOTE: The DRIVE control levers are spring-loaded and will automati-
cally return to neutral (OFF) position when released.
5. Drive/Steer
Provides for driving either forward or backward. The control-
ler is infinitely proportional to allow variable drive speed.
Steering is controlled by a thumb operated switch on top of
the joystick.
3-11