Installing The Chassis In A Two-Post Rack - Cisco Wide Area Application Engine 612 Hardware Installation Manual

Chapter 3 Installing the Cisco Wide Area Application Engine
Warning To prevent bodily injury when mounting or servicing this unit in a rack, you
must take special precautions to ensure that the system remains stable. The
following guidelines are provided to ensure your safety:

Installing the Chassis in a Two-Post Rack

OL-9137-02
• This unit should be mounted at the bottom of the rack if it is the only unit in the rack.
• When mounting this unit in a partially filled rack, load the rack from the bottom to the
top with the heaviest component at the bottom of the rack.
• If the rack is provided with stabilizing devices, install the stabilizers before mounting
or servicing the unit in the rack.
The chassis mounts to two rack posts with brackets that attach to the sides of the
chassis. These brackets are for a 19-inch (48.26-cm) equipment rack and require
four screws in each bracket. (See
Figure 3-1 Rack-Mount Brackets
Orientation for 19-inch rack
Cisco Wide Area Application Engine 512 and 612 Hardware Installation Guide
Installing the Cisco Wide Area Application Engine
Statement 1006
Figure 3-1.)
3-3