Cisco Wide Area Application Engine 612 Hardware Installation Manual page 60

Installing the Cisco Wide Area Application Engine
Figure 3-6
1
3
Repeat these steps for the right slide rail. Make sure that you attach the second
Step 5
slide rail at the same rack height as the first one so that the chassis will be level
in the rack.
Step 6 To install the chassis in the rack, align the chassis on the slide rails and push the
chassis fully into the rack. Secure the chassis to the front mounting flanges with the
captive thumbscrews (labeled 1 in
Note
Cisco Wide Area Application Engine 512 and 612 Hardware Installation Guide
3-8
Attaching the Slide Rail to the Front Mounting Flange—Left
Front Rail Shown
2
Pins
Slide rail pin bracket
You must leave the shipping brackets (labeled 2 in
the slide rails unless the shipping brackets impede the chassis from
sliding fully into the rack. If you need to remove the shipping brackets,
continue with Step
Chapter 3 Installing the Cisco Wide Area Application Engine
Pins extended through
3
the mounting flange and
slide rail pin bracket
1
Pins not extended
through the mounting
flange and slide rail
pin bracket
2
Latch tab
Figure 3-7).
7.
Figure 3-7) attached to
OL-9137-02