Installing Adapters
Disconnect the power cord and then all external cables from the device.
Step 3
Remove the device cover.
Step 4
Grasp the riser card at the rear edge and lift to remove the riser card assembly.
Step 5
(See
Figure 4-2
1
Place the riser card assembly on a flat, static-protective surface.
Step 6
Remove the expansion slot cover for Slot 1. (See
Step 7
Note
Cisco Wide Area Application Engine 512 and 612 Hardware Installation Guide
4-4
Figure
4-2.)
Removing the Riser Card Assembly
1
2
Rear
Riser card assembly
PCI expansion slot covers must be installed on all vacant slots. This
maintains the electronic emissions characteristics of the device and
ensures proper cooling of device components.
Chapter 4
Installing Hardware Options
Front
2
Rear edge of riser card
Figure
4-3.)
OL-9137-02