Cisco Wide Area Application Engine 612 Hardware Installation Manual page 46

Safety Warnings
Before working on a chassis or working near power supplies, unplug the power
Warning
cord on AC units. Statement 246
Do not work on the system or connect or disconnect cables during periods of
Warning
lightning activity. Statement 1001
Read the installation instructions before connecting the system to the power
Warning
source. Statement 1004
Warning To prevent bodily injury when mounting or servicing this unit in a rack, you
must take special precautions to ensure that the system remains stable. The
following guidelines are provided to ensure your safety:
•
•
•
There is the danger of explosion if the battery is replaced incorrectly. Replace
Warning
the battery only with the same or equivalent type recommended by the
manufacturer. Dispose of used batteries according to the manufacturer's
instructions. Statement 1015
Cisco Wide Area Application Engine 512 and 612 Hardware Installation Guide
2-2
Chapter 2
This unit should be mounted at the bottom of the rack if it is the only unit in the rack.
When mounting this unit in a partially filled rack, load the rack from the bottom to the
top with the heaviest component at the bottom of the rack.
If the rack is provided with stabilizing devices, install the stabilizers before mounting
or servicing the unit in the rack.
Preparing to Install the Cisco Wide Area Application Engine
Statement 1006
OL-9137-02