Cisco Wide Area Application Engine 612 Hardware Installation Manual page 57

Chapter 3 Installing the Cisco Wide Area Application Engine
Figure 3-3
Rear of rail
1
3
These slide rails come with spring-loaded locking pins at both ends of each rail.
To attach the slide rails to an equipment rack, you need to pull back the pin
carriage, align the pins with holes in the equipment rack-mounting flange, and
release the pin carriage to lock the pins into the rack posts. A rail-adjustment
bracket allows you to adjust the length of the slide rails to fit the rack. (See
Figure
The chassis rests on the lower ledges provided by the two rails and slides in and
out of the rack along the rail ledges.
To install the chassis in a four-post rack, follow these steps:
To begin, open the pin carriages at the front and rear of the left slide rail:
Step 1
•
OL-9137-02
Rack-Mount Installation Kit
4
2
Slide rails (2)
M6 screws (6)
3-4.)
On the front of the rail, press on tabs labeled (2) and (3) in
the pin carriage toward the rear of the rail, releasing the latch tab (2) as it catches
in place.
Cisco Wide Area Application Engine 512 and 612 Hardware Installation Guide
Installing the Cisco Wide Area Application Engine
Front of rail
1
3
2
Shipping bracket
4 Cable straps (6)
Figure 3-4, and slide
3-5