Cisco Wide Area Application Engine 612 Hardware Installation Manual page 59

Chapter 3 Installing the Cisco Wide Area Application Engine
Note
Figure 3-5
Pins extended through
the mounting flange and
slide rail pin bracket
1
To secure the front of the slide rail to the equipment rack, align the pins (labeled 1 in
Step 4
Figure
rail length, push the pin carriage back toward the rear of the slide rail. Press the latch
tab (labeled 2 in
Note
OL-9137-02
Ensure that the pins are fully extended through the mounting flange and slide
rail pin bracket. (See
Attaching the Slide Rail to the Rear Mounting Flange—Left
Front Rail Shown
Release tab for the rail-adjustment
bracket
3-6) on the front pin carriage to the front mounting flange. If you adjusted the
Figure 3-6) to release the front pin
Ensure that the pins are fully extended through the mounting flange and
the slide rail pin bracket
Cisco Wide Area Application Engine 512 and 612 Hardware Installation Guide
Installing the Cisco Wide Area Application Engine
Figure 3-5.)
2
Pins not extended
through the mounting
flange and slide rail
pin bracket
2 Latch tab
(labeled 3 in Figure
1
carriage.
3-6).
3-7