Table of Contents
Advertisement
1.G. Environmental Requirements
Shipping and Storage conditions for QuantiFluor™ Fluorometers:
5–40°C under noncondensing conditions, up to 75% humidity
Operating conditions for QuantiFluor™ Fluorometers:
15–30°C, up to 75% humidity, height above sea level: up to 2000m
2.
Setting Up the QuantiFluor™ Handheld Fluorometers
QuantiFluor™-ST Fluorometer
1.
Position the instrument on a flat surface.
2.
Choose the appropriate AC plug for your wall outlet. If you need to remove a plug from the adapter,
depress the button immediately underneath the plug and slide the plug off the AC adapter (Figure 1).
Slide the desired AC plug onto the Adapter from the top until it clicks into place.
Figure 1. Placing the plug on the AC Adapter. Depress the button immediately underneath the plug (arrow 1), and
slide the plug off the AC Adapter in the direction of arrow 2. Choose the appropriate plug and slide onto the AC
Adapter from the top down until it clicks into place.
3.
Plug the AC into the QuantiFluor™ Fluorometer (Figure 2).
Be sure to use only the AC Adapter provided with your instrument. Powering the instrument with an
unapproved AC Adapter may damage the unit.
4.
Plug the AC Adapter into a wall outlet.
Figure 2. Top view of the QuantiFluor™-ST Fluorometer showing the AC Adapter Input.
5.
To turn on the QuantiFluor™-ST, press the ON/OFF button. The instrument takes 5 seconds to warm
up. After the warm-up, the QuantiFluor™-ST is ready for operation.
6.
To adjust the brightness of the LCD, press the UP ARROW or DOWN ARROW buttons.
Promega Corporation · 2800 Woods Hollow Road · Madison, WI 53711-5399 USA · Toll Free in USA 800-356-9526 · Phone 608-274-4330 · Fax 608-277-2516 · www.promega.com
Printed in USA.
Revised 1/11
1
2
AC Adapter input
Serial port
Part# TM338
Page 7
Advertisement
Table of Contents
