Promega QuantiFluor E6090 Technical Manual page 9

Handheld fluorometers
Table of Contents

Advertisement

QuantiFluor™-P Fluorometers
1.
On the back of the instrument, loosen the screw and pull the screw up to remove the battery panel
(Figure 3).
2.
Install the 4 AAA batteries into the appropriate spaces. Replace the battery panel and tighten the
screw. The panel has an o-ring, which creates a water-tight seal. The battery panel may be difficult to
install if there is no lubrication on the o-ring. Use a silicon-based grease to lightly lubricate the o-ring,
if necessary.
Figure 3. Back Panel of the QuantiFluor™-P Fluorometer showing the battery compartment.
ON/OFF
instrument on and off.
STD VAL
set numeric value for the
DATA
access IDL screens
(Internal Data Logging).
Figure 4. Front Panel of the QuantiFluor™-ST Handheld Fluorometer. The control panel of the QuantiFluor™-P
instrument is identical.
Promega Corporation · 2800 Woods Hollow Road · Madison, WI 53711-5399 USA · Toll Free in USA 800-356-9526 · Phone 608-274-4330 · Fax 608-277-2516 · www.promega.com
Part# TM338
Page 8
Indicates active
channel.
A/B
button. Press
to select channel.
ESC
button.
button. Turns the
UP ARROW
button.
button. Press to
standard solution.
button. Press to
xx.x
UV
Fluorescence reading.
HOME
screen.
SET
button. Press to
select sample analysis
mode (Discrete or
Continuous).
READ
button. Press to
access READ screens.
CAL
button. Press to
access CALIBRATION
screens.
DOWN ARROW
button.
ENTER
button.
DIAG
button. Press to
access DIAGNOSTICS
screens.
Printed in USA.
Revised 1/11

Advertisement

Table of Contents
loading

This manual is also suitable for:

Quantifluor e6105Quantifluor e6100

Table of Contents