Table of Contents
Advertisement
4.
Internal Data Logging (IDL; additional information is available in Section 7)
4.A. Activating IDL
1.
Press the DATA button 2 times.
2.
Press the ENTER button to choose between logging and stop.
3.
Press the ESC button when finished to return to the HOME screen.
Note: Once activated, the IDL is capable of storing 1000 data points
4.B. Downloading Data to a Computer
Important Note: Before you can download data that have been logged on your QuantiFluor™
Fluorometer to a computer, that computer must have the Spreadsheet Interface Software Installed. See
Section 7 for computer requirements and installation instructions.
1.
Connect the QuantiFluor™ Fluorometer to the computer serial port using the provided
interface cable.
2.
Open the Spreadsheet Interface Software.
3.
Press the DATA button 3 times. The screen will display: "Download data: 5X<ENT> to start".
4.
Press the ENTER button 5 times to start downloading the data.
5.
Press the ESC button when the data have downloaded to return to the HOME screen.
Note: If no data are logged, the screen will display the following message "Data logger has no
valid data."
4.C. Erasing Data from the QuantiFluor™ Instrument
1.
Press the DATA button 4 times. The screen will display "Erase data: 5X <ENT> to start."
2.
Press the ENTER button 5 times to erase all logged data from the QuantiFluor™ Instrument. When
the data are erased, the screen will display the following message: "Erase Data All data erased."
3.
Press the ESC button to return to the HOME screen.
Promega Corporation · 2800 Woods Hollow Road · Madison, WI 53711-5399 USA · Toll Free in USA 800-356-9526 · Phone 608-274-4330 · Fax 608-277-2516 · www.promega.com
Printed in USA.
Revised 1/11
Part# TM338
Page 15
Advertisement
Table of Contents
