Hp Setup Program - HP Vectra XM5 4 User Manual

When you press [ESC], the HP Summary Screen, similar to the following one, will appear:
XM/100 Series 4 - Copyright 1995 Hewlett-Packard - QA.xx.xx
BIOS Version
CPU Date Code
System RAM
Bank A
Bank B
Bank C
Video RAM
System Cache
Video Device
1st IDE Device
2nd IDE Device
3rd IDE Device
4th IDE Device
ISA PnP : Not Installed
ISA PnP : Not Installed
ISA PnP : Not Installed
<F1> to continue, <F2> to run Setup, <F10>to power off, <F5> to retain
This screen gives you a summary of the current configuration settings of your PC.

HP SETUP PROGRAM

From either the "Vectra Logo" screen (during POST) or the Summary Screen, press [F2] to go
to the Setup program.
Setup is an integrated (ROM-based) program that displays the PC's configuration items and
allows you to set parameters for these items.
If, during POST, an error message is displayed, refer to chapter 4, Troubleshooting Your PC.
Setup changes system behavior by modifying the power-on initialization parameters. Setting
incorrect values may cause system boot failure. Should this occur, press [F9]. This will load
Setup default values to recover.
NOTE
: GW.O5.xx
: N/A
: 16 MB
: 8 MB (EDO)
: None
: None
: 1 MB
: None
: S3
: HDD 848 MB
: None
: None
: None
If you are unable to change the PC's configuration,
check that you entered the correct password when
you started Setup and whether the Secure switch
(system board switch 8) is set to the OPEN position.
For further information on switches refer to "System
Board Connectors and Switches" in chapter 5.
PC Serial Number
LAN Mac Address
COM1
COM2
COM3
COM4
LPT1
LPT2
LPT3
Flexible Disk A
Flexible Disk B
Display type
PCI Slot #1 : Not Installed
PCI Slot #2 : Not Installed
: FR54011111
: 08-0009-85-03-00
: 3F8H (Serial A)
: 2F8H (Serial B)
: None
: None
: 378H
: None
: None
: 1.44 MB
: None
: Not Available