The Hp Summary Screen And Setup Program - HP Kayak XA-s 02xx Manual

HP Kayak XA-s 02xx PC Workstation - Setting Up and Using Your HP Minitower PC Workstation

The HP Summary Screen and Setup Program

You can use the Summary Screen and the Setup program to configure
your PC Workstation and solve configuration problems with your PC
Workstation.
Viewing the HP Summary Screen
Check your PC Workstation's configuration when you first use the PC
Workstation and each time after you install, remove, or upgrade
accessories. To check the configuration:
1 Turn on the display and then the PC Workstation. If the PC
Workstation is already turned on, save your data and exit all
programs, then restart the PC Workstation. Consult your operating
system documentation for any special instructions concerning
turning off and then restarting your PC Workstation.
2 While the start-up logo appears on your display, press
takes you to the HP Summary Screen. (To go immediately into the
Setup program, and bypass the Summary Screen, press
of ). The Summary Screen is displayed for only a short time. To
retain the screen (until you decide to leave it), press
Starting the HP Setup Program
1 Turn on the display and then the computer. If the PC Workstation is
already turned on, save your data and exit all programs, then restart
the PC Workstation. Consult your operating system documentation
for any special instructions concerning turning off and then
restarting your PC Workstation.
2 Press while
If you fail to press
you will need to restart your PC Workstation to go through the
POST again so you can press
3 The opening screen of the PC Workstation's Setup program is
displayed, similar to the one on the next page. Note that the Main
menu selection is highlighted.
The HP Summary Screen and Setup Program
is displayed at the bottom of the screen.
Setup
in time and the start-up process continues,
.
. This
instead
.
English 11