IF YOUR PC HAS A SOFTWARE PROBLEM
If You Have Forgotten Your Password
•
If you forget the User Password, but not the Administrator password, carry out the
following procedure:
1
Restart the PC. If the keyboard is locked, enter the administrator password.
2
Wait for F2=Setup to be displayed.
Press [F2] to start Setup .
3
4
Enter the Administrator Password to access the Security/User Password menu.
5
Move to the User Password field and set a new User Password. This will replace the
old password which you had forgotten.
6
Press [F3] to save the new Password and exit Setup.
•
If you forget both the User Password and the Administrator Password:
1
Switch off the PC.
2
Remove the computer's cover.
3
Set switch 5 (PASWD EN) on the system board switch block to CLOSED.
4
Switch on the PC and allow it to complete its startup routine.
The message "Passwords have been cleared, power-off your PC and
set switch 5 to open position before restarting" will be displayed.
5
Switch off the computer.
6
Reset switch 5 (PASWD EN) to OPEN.
7
Replace the computer's cover.
8
Switch on the PC and allow it to complete its startup routine.
9
After the Power-On Self-Test has completed, press [F2] when prompted to use Setup .
10 Set new User and System Administrator Passwords.
11 Press [F3] to save the new passwords and exit Setup .
IF YOUR APPLICATION SOFTWARE DOES NOT WORK
If the PC reports the system is OK and the indicator light over the power switch is illuminated,
but some software won't run:
•
Check to see if the AUTOEXEC.BAT file is present with the correct settings (Windows
3.11 only). Refer to the operating system and application software manuals.
•
If Windows does not run properly, refer to the Windows manual for guidance.