Installing The Board - HP Vectra XM5 4 User Manual

4 Double-click on the ICU icon to launch the ISA Configuration Utility and configure system
resources for the accessory board.
The ICU is preloaded with configuration details for many non-Plug and Play accessory
boards. If your accessory board is not listed by the ICU, you have two options:
a Some non-Plug and Play accessory boards are supplied with a configuration file,
which can be used by the ICU to determine which resources are required by the board.
Insert the disk containing the configuration file when prompted by the ICU.
b If you do not have a configuration file for your accessory board, you will need to enter
the configuration details manually when prompted by the ICU. Refer to the
documentation supplied with your accessory board for information on the resources
required by the board.
Windows 95
For Windows 95 you will need to run the Add New Hardware wizard to configure the
accessory board. The settings selected by Windows 95 may be different from those
recommended by the board's manufacturer. Should this be the case, it might be necessary to
alter the board's jumpers. Refer to the documentation supplied with Windows 95 for further
details.
Other Operating Systems
For other operating systems, refer to the documentation supplied with the operating system for
details on how to configure non-Plug and Play accessory boards.

INSTALLING THE BOARD

1 Disconnect the computer's power supply cord and any connection to a
telecommunications network.
2 Remove the computer's cover and power supply.
3 Find a free slot. Some boards may have preferred locations and special installation
instructions detailed in their manuals.