Installing A Tape Drive In The Bottom Shelf - HP Vectra VE5 3 User Manual

2
2 How to Install Accessories In Your PC
Installing Mass Storage Devices
8 Support the power supply with your hand and very carefully return
the PC to the upright position.
9 Connect the data and power cables to the rear of the drive.
The connectors are shaped to fit one way only. If you are not sure
which connector to use, refer to "Connecting IDE Devices", on page
21.
Data cable
10 Replace the CD-ROM (if present) in the middle shelf.
11 Install any other accessories before replacing the cover. Replace the
side bezel. Reconnect all cables and power cords.
12 Verify the new configuration by checking the HP Summary Screen.
Refer to the "The HP Summary Screen", on page 38.

Installing a Tape Drive in the Bottom Shelf

A tape drive can be installed in the bottom shelf.
1 Disconnect the computer's power supply cord from the power outlet,
and disconnect the PC from any telecommunications network.
2 Remove the computer's cover.
3 Remove the CD-ROM (if present) from the middle shelf, or, if no CD-
ROM, remove middle bezel.
28 English
Power cable