If An Accessory Board Does Not Work - HP Vectra VE5 3 User Manual

CD-ROM Drive is Idle
If the CD-ROM drive does not appear to be working, try accessing the
disk by clicking on the CD-ROM drive icon or drive letter assigned to
the CD-ROM drive by your operating system.
CD-ROM Drive Does Not Work
Check that the cables have been properly connected.
•
Check that a CD is inserted in the drive.
•
Verify that the CD-ROM is declared as "CD" in the Setup program.
•
Verify that the
•
Bus IDE Adapters
If you intend to boot on CD-ROM, make sure that this option is
•
enabled in Setup.
For further information refer to the CD-ROM documentation.
•

If an Accessory Board Does Not Work

Carry out the following checks:
Ensure the board has been firmly installed in the accessory board
•
slot.
Check that the accessory board has been correctly configured with
•
the Intel ISA Configuration Utility (available on PCs preloaded with
Windows for Workgroups 3.11) if necessary.
Ensure the board is not using memory, I/O addresses, an IRQ, or
•
DMA also used by the PC. Refer to "IRQs, DMAs, and I/O Addresses",
on page 60. Refer to the board's manual for further details.
Check that the PC has been configured correctly in Setup.
•
If the problem persists, refer to HP support.
•
4 Troubleshooting Your PC
If Your PC Has a Hardware Problem
item is set to in Setup.
Both
English 53
4