HP Vectra VE5 3 User Manual page 57

Clearing the PC's Configuration Memory
If the PC then starts, but POST still persists in reporting an error, clear
the current configuration memory values and reinstall the built-in
default values:
1 Turn off the PC, disconnect the power and cables, and remove the
cover. Disconnect the PC from any telecommunications network.
a Set the system board switch SW1-2(CMOS) to ON to clear the
configuration.
b Replace the cover, and reconnect the power cable only.
c Turn on the PC. This will erase the CMOS memory.
d Wait until the PC has started. A message will be displayed similar
to this:
"Configuration has been cleared, set switch SW1-2 to the
open position before rebooting."
Turn off the PC, disconnect the power cable, and remove the
cover.
e Set the system board switch SW 1-2 (CMOS) on the switch block
to OFF to re-enable the configuration.
2 Replace the cover, and reconnect the power and cables.
3 Switch on the PC. An error message will be displayed similar to this:
"Incorrect PC configuration"
The PC will stop.
4 Run Setup by pressing
automatically downloaded and saved.
5 Make any other changes you want and press
configuration and exit from Setup.
4 Troubleshooting Your PC
If Your PC Does Not Start Properly
. CMOS default values will be
to save the
English 47
4