Magnetek IMPULSE G+ Mini Technical Manual page 118

Parameter
L08.15 OL2 Sel @ Low Spd
00 Disabled
01 Enabled
L08.18 Soft CLA Sel
00 Disabled
01 Enabled
L08.19 Overheat Pre-Alarm Frequency
Reduction Rate
L08.35 Mounting Selection
00 Open Chassis
01 Side-by-Side
02 NEMA 1
03 Finless
L08.41 High Current Alarm Selection
00 Disable
01 Enable
* Value depends on VFD model
Name
Enables/disables OL when output frequency <
6 Hz
NOTE: Setting depends on D10.02
Enables/disables the software current limit
function. Limits output frequency when current
exceeds 110% of rated.
Specifies the frequency reference reduction
gain at overheat pre-alarm when L08.03 = 4.
Mounting selection
High current alarm selection
Function
IMPULSE
Range Default
00, 01 01
00–01 01
0.1–0.9% 0.8
00–03 00
00–01 00
®
•G+ Mini Technical Manual
November 2020
Page 118