Table of Contents
Advertisement
Chapter 4
Connect the Management Interfaces and Perform Initial System Configuration
Table 4-1
Parameter
Access Control List number
list entries (maximum 20 per list)
IP access ACL
telnet ACL
SNMP agent status
GET community names
SET community names
trap managers (maximum 20)
Authentication Failure trap status
enterprise traps status
system administrator
Topology Configuration
connection mode
link bypass mode on operational status
link bypass mode on non-operational status
priority
(cascade topology only)
operational status of the SCE after abnormal boot After a reboot due to a failure, should the SCE
Following are some general instructions regarding the setup dialog:
All default values appear in square brackets [default] .
•
If no value appears in the brackets [], or more than one option appears [ yes/no ], then this parameter
does not have a default value.
OL-7822-06
Setup Command Parameters (continued)
Perform the Initial System Configuration
Definition
How many ACLs will be necessary? What IP
addresses will be permitted/denied access for each
management interface? You may want ACLs for
the following:
Any IP access
•
Telnet access
•
•
SNMP GET access
•
SNMP SET access
IP address, and whether permitted or denied
access.
ID number of the ACL controlling IP access.
ID number of the ACL controlling telnet access.
Enable or disable SNMP management.
Community strings to allow GET access and
associated ACLs (maximum 20).
Community strings to allow SET access and
associated ACLs (maximum 20).
Trap manager IP address, community string, and
SNMP version.
Sets the status of the Authentication Failure traps.
Sets the status of the enterprise traps.
Name of the system administrator.
Is the SCE 1000 installed using inline topology or
receive-only topology using an optical splitter?
When the SCE 1000 is operational, should it
bypass traffic or not?
When the SCE 1000 is not operational, should it
bypass traffic or cut it off?
If this is a cascaded topology, is this SCE 1000 the
primary or secondary SCE 1000?
1000 remain in a Failure status or move to
operational status provided no other problem was
detected?
Cisco Service Control Engine 1000 2xGBE Quick Start Guide
4-5
Advertisement
Table of Contents
