Connecting the Power
Look at the IN and OK LEDs on the power supply unit and the corresponding Power LED on the front
Step 7
panel. If the DC-input power supply unit is operating properly, these LEDs will be glowing green.
Ensure that the power supply is properly aligned and the installation screw is tightened.
Step 8
Connect the AC-Input Power Supply Unit
Step 1
Plug the AC-input power cable into the AC-input power receptacle on the AC-input power supply
For AC-input power, we recommend powering the SCE 2000 platform from a 120 VAC, 15A receptacle
U.S. (240 VAC, 10A international) at the power source.
Figure 3-4
Plug the AC power supply cable into the AC power source.
Step 2
Turn the on/off switch to the on position.
Step 3
Step 4
Look at the IN and OK LEDs on the power supply unit and the corresponding Power LED on the front
panel. If the AC-input power supply unit is operating properly, these LEDs will be glowing green.
Step 5
Ensure that the power supply is properly aligned and the installation screw is tightened.
Cisco Service Control Engine 1000 2xGBE Quick Start Guide
3-4
Connecting the AC Power
BY PA SS
1
IN
PO W ER B
OK
IN
PO W ER A
OK
Chapter 3
Connect the Power Supply Units
OL-7822-06