Table of Contents
Advertisement
Chapter 5
Cable the Line Ports
Figure 5-2
PWR A
Cabling the Line Interfaces
•
•
Configure GigabitEthernet Auto-Negotiation
By default, the SCE 1000 GBE line interface ports are configured with auto-negotiation disabled.
Note
If you change any parameters, you must save the new configuration settings. Type
running-config startup-config
Step 1
At the SCE 1000# prompt, type
Enters Global Configuration Mode.
At the SCE 1000(config)# prompt, type
Step 2
Enter.
Enters the GigabitEthernet Interface configuration mode for the specified GBE port.
portnumber
Step 3
At the SCE 1000(config if)# prompt, type
Enables auto-negotiation for the GBE interface.
Step 4
At the SCE 1000(config if)# prompt, type
OL-7822-06
External Splitting Topology
PWR B
STATUS
BYPASS
Router
Subscriber
Configure GigabitEthernet Auto-Negotiation, page 5-3
Connect the GBE Line Interface Ports, page 5-4
is the number of the selected port (1 or 2).
LINK RX TX
LINK RX TX
RX
MM
TX
RX
MM
TX
GBE-1
SUB
LINE
NET
Optical
splitter
, and press Enter.
and press press Enter.
configure
interface GigabitEthernet 0/ portnumber
auto-negotiate
and press press Enter.
exit
Cisco Service Control Engine 1000 2xGBE Quick Start Guide
Cabling the Line Interfaces
Cisco SCE 1000
2xGBE
Router
copy
, and press press
and press press Enter.
Series
Network
5-3
Advertisement
Table of Contents
