Table of Contents
Advertisement
Connect the Management Interfaces and Perform
Initial System Configuration
This section explains how to connect the SCE 1000 platform to a local console and perform the initial
system configuration via the setup wizard that runs automatically. Additionally, this section contains
instructions for cabling the Fast Ethernet Management interface.
•
•
•
Connect the Local Console
Figure 4-1
1
You must first connect the unit to a local console and configure the initial settings for the SCE 1000 to
support remote management. When the initial connection is established, the setup utility will run
automatically, prompting you to perform the initial system configuration.
Make sure that the terminal configuration is as follows:
•
•
•
•
•
OL-7822-06
Connect the Local Console, page 4-1
Perform the Initial System Configuration, page 4-2
Connect the Management Interface, page 4-25
Connecting to the Local Console
MN G 1
MN G 2
CO NS OL
E
AU X
LIN K/
10/1 00/
ACT IVE
LIN K/
100 0
10/1 00/
ACT IVE
100 0
2
3
9600 baud
8 data bits
No Parity
1 stop bits
No flow control
C H A P T E R
PW R A
PW R B
STA TU S
BY PAS S
C is co S
C E 1 0 0 0
Se rie s
LIN K RX
2 xG B E
TX
LIN K RX
TX
RX
MM
TX
RX
MM
TX
GB E-1
SU B
LIN E
NE T
Cisco Service Control Engine 1000 2xGBE Quick Start Guide
4
4-1
Advertisement
Table of Contents
