Battery Charger; Bars And Chains; Battery Backpack; Battery Simulator - Stiga CS 700 Li 48 Operator's Manual

Battery powered chainsaw for tree service
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 174

15.2 BATTERY CHARGER

Device used to recharge the battery (Fig. 39).

15.3 BARS AND CHAINS

The "Correct bar and chain combination table"
contains a list of all possible combinations
between bar and chain. The same table also
provides the specification data for all chains and
bars approved for use on each machine.
Only use the replacement bars and chains
listed in the table. The use of unapproved
combinations may be hazardous and cause
serious injuries to operators and damage the
machine.
In consideration that the selection,
application and use of the bar and chain are
actions made solely by the user, at his own
discretion, the latter assumes responsibility
for damages of any kind arising from such
actions. When in doubt or if lacking knowledge
of the specifics of each bar or chain, contact
your dealer or an authorised garden centre.

15.4 BATTERY BACKPACK

Device which allows the housing of two batteries
and provides the power needed to operate the
machine.
It is equipped with the cable to connect to
the machine (Fig. 1.N) and a selector switch
(Fig.
14.B) which allows you to select one of the
two batteries ( position "1" and "2") and "OFF".

15.5 BATTERY SIMULATOR

Device that, if inserted in the machine housing,
allows the use of the battery backpack (Fig.1.O)
EN - 20

Advertisement

Table of Contents
loading

Table of Contents