Changing A Programme; Adding An Extra Dish; At The End Of A Programme - Sandstrom SDW60W14N Installation Instructions Manual

Changing a Programme

To change the programme if the washing cycle has already started, follow the steps below.
1. Open the door slightly to avoid water spillage before opening the door fully. Check if the
unit has dispensed the detergent or detergent tablet. This will depend on how long the
GB
washing cycle was running for.
2. If the detergent dispenser lid is opened, we suggest you to allow the wash cycle to complete.
3. If the detergent dispenser lid is still closed, close the dishwasher door, press and hold the P
program button for 3 seconds to cancel the programme. You can then select the required
new programme button and then press the
cycle shortly.
• If you open the door during a wash cycle, the machine will pause. The programme light will stop blinking
and the machine will beep once a minute until you close the door. After closing the door, the machine will
automatically continue the wash cycle after 10 seconds.
• If you open the door during a wash cycle, the steam and / or hot water may scald you.

Adding An Extra Dish

If you need to add an extra dish, you can so so before the detergent cap opens.
1. Press .
2. Open the door a little to avoid waters spillage. Wait for the spray arms to stop spinning. Open
the door completely.
3. Add the extra dish(es).
4. Close the door.
. The machine will automatically continue the wash cycle after 10 seconds.
5. Press

At the End of a Programme

At the end of the programme, the dishwasher will beep for 8 seconds.
1. The programme light will illuminate solidly. Press
2. Open the door carefully and fully, escaping steam and remaining water may scald.
3. Wait about 15 minutes before unloading the dishwasher (see the section, "Unloading the
Dishwasher".)
The condensation strip helps prevent the risk of steam damage to the worktop edging above the
dishwasher. It is advisable to leave the door closed until you are ready to unload the crockery. Do not leave
the door only partially open. Do not leave the appliance unattended with the door fully open as this could
present a trip hazard.
40
button. The unit will start the new washing
to turn off the machine.