Table of Contents
Advertisement
Available languages
Available languages
Changing a Programme
To change the programme if the washing cycle has already started, follow the steps below.
1. Open the door slightly to avoid water spillage before opening the door fully. Check if the unit has
dispensed the detergent or detergent tablet. This will depend on how long the washing cycle was
running for.
2. If the detergent dispenser lid is opened, we suggest you to allow the wash cycle to complete.
3. If the detergent dispenser lid is still closed, press and hold down the P program button for 3 seconds
to cancel the programme. You can then select the required new programme button and close the
dishwasher door. The unit will start the new washing cycle shortly.
At the End of a Programme
At the end of the programme, the dishwasher will beep.
The condensation strip helps prevent the risk of steam damage to the worktop edging above the
dishwasher. It is advisable to leave the door closed until you are ready to unload the crockery. Do not
leave the door only partially open. Do not leave the appliance unattended with the door fully open
as this could present a trip hazard.
Switching Off the Unit
To save energy, remember to switch the dishwasher off using the
continue to use electricity until it is switched off with the
If the dishwasher is not going to be used for a long period of time, e.g. whilst on holiday, disconnect
the unit from the mains supply.
Unloading the Dishwasher
Allowing dishes to cool down before unloading is important as dishes tend to break and chip more easily
when they are hot. Therefore, if you open the dishwasher door fully after switching off, it will allow the
dishes to cool down much faster.
Unload the lower basket first, followed by the cutlery basket and then the upper basket. This will
prevent water drops from the upper basket from falling on to the dishes in the lower basket.
On/Off button. The dishwasher will
On/Off button.
GB
41
Advertisement
Table of Contents
