Suzuki GSX1300R Owner's Manual page 26

If the meter needle does not point
to zero, follow the procedure
below to reset the meter.
1. Press and hold the ADJ button
H and turn on the ignition
switch.
2. Hold the ADJ button H for 3 –
5 seconds.
3. Release the ADJ button H.
Rap the ADJ button twice.
NOTE: Reset procedure, from
step 1 to step 3, should be per-
formed within 10 seconds.
Fuel Meter "" 1
The fuel meter indicates amount
of gasoline remaining in the fuel
tank. The "E" mark indicates the
fuel tank is empty or nearly so.
The "F" mark indicates the fuel
tank is full.
Turn Signal Indicator Light
"" 2
When the turn signals are being
operated either to the right or to
the left, the indicator will flash at
the same time.
A
B
C
NOTE: If a turn signal light is not
operating properly due to bulb fila-
ment or circuit failure, the indica-
tor light flickers more quickly to
notify the rider of the existence of
a trouble.
Tachometer 3
The tachometer indicates the
engine speed in revolutions per
minute (r/min).
Gear Position Indicator 4
The gear position indicator indi-
cates gear position. This indica-
tor displays
transmission is in neutral.
Fuel Indicator Light "" 5
This indicator light comes on for 3
seconds when the ignition switch
is turned to the "ON" position.
Then the indicator light should go
out if there is enough fuel in the
tank. When the fuel in the fuel
tank drops below approximately
5.0 L (1.3 US gal), this indicator
light comes on and remains on.
NOTE: When the fuel indicator
light comes on, you should add
fuel to the fuel tank at the first
opportunity to avoid running out of
fuel.
3-8
"0" when the