Cleaning And Assembly - Prince Castle FLAME KING BROILER Install & Operation Manual

Table of Contents

Advertisement

Turn broiler off and close the main gas valve. Disconnect the power supply to the broiler before cleaning or ser-
vicing. If this broiler is connected using a restraint and disconnection of the restraint is necessary for cleaning
or moving the broiler, the restraint must be reconnected after the broiler has been returned to its originally-
installed position. Allow to cool for 30 minutes prior to cleaning/disassembly. Leave the ventilation system on
during cooling. Use only approved cleaning, degreasing, and sanitizing solutions.
WARNING
LEAVE THE VENTILATION
HOOD ON DURING COOLING.
FAILURE TO DO SO COULD
POSE A FIRE SAFETY
HAZARD.
ALL PARTS ARE CLEANED ON A DAILY BASES UNLESS OTHERWISE NOTED
Name of the part
to be cleaned.
HEAT VENT
Tools needed to
clean the part.
How to remove
and clean the
parts.
When to clean the
part.
PN: 1000-605 | User Manual – Prince Castle Flame King Broiler
Rev: A
Updated: 4/13/2022

CLEANING AND ASSEMBLY

Follow the disassembly and
reassembly steps to ensure
proper operation of the broil-
er. Failure to do so may result
in operational problems.
Follow the steps for proper disassembly. Reverse the order for reassembly.
How to read the cleaning section
Tools:
Instructions:
1. Pull each heat vent out slightly
from the bottom, then lift off.
2. Wash, rinse, and sanitize in
the 3-compartment sink.
Clean:
Once daily
FLAME KING BROILER
CAUTION
22
WARNING
BROILER PARTS ARE HOT. DO NOT
ATTEMPT TO DISASSEMBLE THE
BROILER UNTIL IT IS FULLY COOL.
FAILURE TO FOLLOW THIS INSTRUC-
TION MAY RESULT IN SEVERE INJURY.
The location of
the part.
Feed End
Picture of the part
to be removed
and cleaned.

Advertisement

Table of Contents
loading

Table of Contents