Download Print this page

Operation; Cleaning; Setting Temperature - Prince Castle DHB2PT-20PUBGBN Operation Manual

Product holding bin

Advertisement

Operation

Turn power On/Off switch to ON position.
1
Power On/Off Switch
2
To shut down the unit, turn the power On/Off switch to OFF.
The unit has two shelves, each with an upper and lower heater (four heaters total).
1
Each upper heater has a programmable range of 150° – 350°F (65.6° – 176.7°C).
Each lower heater has a programmable range of 150° – 260°F (65.6° – 126.7°C).
Use the control below and the following steps to set the setpoint temperature for each heater.
UPPER SHELF LED
This LED will be lit to indicate upper shelf is
selected.
PROG LED
This LED will blink to indicate unit is in Program
Mode.
LOWER SHELF LED
This LED will be lit to indicate lower shelf is
selected.
ACTUAL TEMP BUTTON and LED
Press to display actual temperature for the
selected heater. LED will be lit and actual
temperature is displayed.
SETPOINT BUTTON and LED
Press to display setpoint temperature of a
selected heater. LED will be lit and setpoint
temperature is displayed.
NOTE: To reset all times and temperatures to the factory settings, turn the unit off, then press and hold the UP and DOWN Arrow buttons simultaneously
while turning the unit back on. A "P" will appear in the display and all times and temperatures will be reset to original factory settings.
540-523_EN rev.D
Allow 30 minutes for
heaters to reach operating
temperature. The
Temperature Display will
show temperature as unit
warms up to the operating
temperature.

Setting Temperature

3
Product Holding Bin

Cleaning

WARNING
Before performing any maintenance, turn the power switch to the
OFF position and unplug the power cord from the electrical
receptacle.
CAUTION
This unit is not watertight. Do not clean with a water jet/jet spray.
Do not immerse the unit in water.
1. Turn the unit off and unplug the power cord from the electrical
receptacle.
2. Wipe all parts and unit with a damp cloth. DO NOT use a green
Scotch Bright pad cleaner, ice or water.
TEMPERATURE DISPLAY
NOTE: The unit is preset to display temperature
in Fahrenheit. To display in Celsius, press and
hold the DOWN Arrow button immediately after
turning on the power switch. To switch back to
Fahrenheit, press and hold the UP Arrow button
immediately after turning on the power switch.
UP/DOWN ARROW BUTTONS
Used with other buttons to scroll through heater
and temperature selections.
PRINCE CASTLE LOGO BUTTON
Press to program temperature selections.
DHB2PT-PUBGBN
Printed in USA 6/10 © 2019

Advertisement

loading