Prince Castle FLAME KING BROILER Install & Operation Manual page 13

B.6 Installing Gas Appliance Connectors and Flexible Gas Lines Correctly
For safety in the kitchen area, and to insure maximum service life, it is vitally important to correctly install
connectors. The connector shall comply with the Standard for Connectors for Moveable Gas Appliances,
ANSI Z21.69 or CAN/CGA-6.16 and a quick disconnect device that complies with the Standard for Quick-
Disconnect Devices for use with gas fuel, ANSI Z21.41 or CAN1-6.9
In order to avoid sharp kinks or excessive bends that could have a damaging effect on the connector, it
may be necessary to attach pipe elbows in order to bring the connector into its proper plane. For easy
movement of the appliance, the connector should be installed with a "lazy" loop for minimum tension.
Note: Gas appliances should be disconnected prior to maximum movement. (Minimal movement is
possible to connect hose.)
A suitable restraint kit must be installed to limit movement of the flexible gas hose.
B.7 Clearance
Keep appliance area free from combustibles.
To facilitate disassembly and service of the unit, a minimum of 24" (610mm) should be allowed on the control panel
(feed end) of the broiler.
REQUIRED AND RECOMMENDED CLEARANCES
Back of broiler
Sides of broiler
Front of broiler
B.8 Electrical Connection
Power requirements are stated on the unit nameplate and must be connected accordingly. Before starting broiler, tighten
all electrical connections in control box. An electrical wiring diagram can be found inside the control box.
Note: Disconnect power before servicing or cleaning.
PN: 1000-605 | User Manual – Prince Castle Flame King Broiler
Rev: A
Updated: 4/13/2022
B. INSTALLATION
Minimum Clearance for
installation near non-
combustible walls and
construction
3" (77 mm)
3" (77 mm)
24" (610 mm)
FLAME KING BROILER
Minimum Clearance
Recommended by
Prince Castle for
proper disassembly
and service
24" (610 mm)
6" (153 mm)
24" (610 mm)
13