Christie M RGB Series Installation And Setup Manual page 39

You cannot move the selected sprite outside the resolution range.
6. Repeat steps 4 and 5 for the other axis.
7. To apply the alignments and update the test pattern (so the effect is seen on the screen), on
the remote press and hold the Enter button.
A countdown is initiated and a message displayed when the alignments are applied.
To apply the alignments to the test pattern at any time, press and hold the Enter button.
Applying alignments to the test pattern does not automatically save the convergence settings
to the projector. For how to save the convergence to the projector, refer to step 10.
8. To adjust remaining corners, repeat steps 3 to 7.
To move to the next corner, on the remote press Back. The Select Corner to Adjust dialog
appears. Use the arrow keys to select the next corner you want to adjust.
9. If the corner adjustment is not what you want or to start over with the alignment, reset the
sprite positions:
a) On the remote, press 0.
b) To reset the selected corner's alignment, select Selected.
c) To reset the alignments for all the corners, select All.
10. To save the convergence and exit, on the remote press Test Pattern.
If no changes have been made, the projector exits the electronic convergence function. If any
changes have been made to the convergence, a Save or Discard Changes dialog appears.
a) To save and exit, select SAVE and ENTER.
The convergence settings are applied and saved to the projector before exiting the
electronic convergence function.
b) To exit without saving, select DISCARD and ENTER.
The convergence settings are not saved to the projector and the previous convergence
settings are applied.
Electronically adjusting convergence through the menu
Use the electronic convergence feature in the menu to adjust convergence.
For an overview of the DMD convergence adjustment process, refer to Adjusting DMD convergence (on
page 36).
• If warping with Christie Twist or Mystique, ensure the warp files are disabled before entering the
electronic convergence feature.
• Christie recommends using the remote to adjust convergence.
1. Before adjusting DMD convergence, ensure the projector has reached a steady operational
state. If switching from a white or bright test pattern to a dark convergence test pattern, or if
warming up the projector after a shutdown, allow 15 minutes for stabilization so the optics can
reach a steady state.
2. To enable electronics convergence, select MENU > Admin > Service > Convergence and
select Enable E-Convergence Adjustment.
The Electronic Convergence test pattern is automatically displayed.
Christie M RGB Series Installation and Setup Guide
020-103483-04 Rev. 1 (04-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
Installation and setup
39