Racelogic Performance Box Touch V2 Quick Start Manual page 20

Reset
Pressing the Reset button at the bottom right of the screen will reset all test results shown on the current screen.
When you press it, the LEDs will briefly flash
Logging
Performance Box Touch logs data via an SD card inserted into the SD Card Slot on the left-hand side of the unit.
Depending on the Logging Strategy you have selected in the
or only when it detects movement.
You can manually override the configured logging
strategy by tapping on the SD Card Icon when it is
green to start or stop the logging.
The Record Icon will show when the unit is logging data
to the SD card.
If you have come to a stop, but the Record Icon is still
on, you must press the SD Card Icon to stop
the logging before you remove the SD card.
Sometimes, due to poor satellite visibility, for example in
a garage or close to a building, Performance Box
Touch may start recording even if the car is stationary.
Always check the Record Icon to make sure the unit is
not recording before you eject the SD card.
IMPORTANT
The SD card should not be removed when
the Record Icon flashes red as it may cause you to
lose data.
Note: If the SD card is removed while the box is still
recording, you may need to repair it on a PC before you
can use it again.
https://en.racelogic.support//Product_Info/Performance_Meters/Performance_Box_Touch/Performance_Box_Touch_V2/
green twice and the unit will emit an audible confirmation notification.
Quick_Start_Guide_%E2%80%93_Performance_Box_Touch_V2/Quick_Start_Guide%3A_Decel_Mode_-
General Settings, the unit will either log continuously
_Performance_Box_Touch_V2
20